Tallaght Driving School · Free student revision guide
Irish Driving Test Technical Checks: Questions, Answers & Checklist
Know what to check, how to explain it and where to find it in your test car. Prepare for under-bonnet questions, tyres, lights, brakes and the controls inside the car.
Tony’s tip: Read it. Say it out loud. Practise it in the car you will use on test day.
What technical checks are asked in the Irish driving test?
For a Category B car test, RSA procedures specify three technical checks selected by the tester from ten areas: tyres, lights, reflectors, indicators, engine oil, coolant, wipers and washer fluid, steering, brakes and horn. Be ready to explain all ten.
If oil, coolant or washer checks are selected, you must be able to open the bonnet and close it securely. Brake fluid and power-steering fluid may also be checked where applicable. Operating the secondary controls is a separate part of your preparation.
The 10 technical checks: practise these answers
1. Tyres
Practice answer: “I check the tread, condition and pressure. There must be at least 1.6mm of tread across the central three-quarters and around the full circumference, with no cuts or bulges. I check cold pressures against the manufacturer’s figures.”
Use a tread gauge. Find the correct pressures in the handbook or vehicle label, often on the door frame or fuel flap. Front and rear pressures may differ. The RSA recommends replacing tyres at 3mm.
Remember: tread · condition · pressure.2. Lights, including brake lights
Practice answer: “I switch the lights on and check around the car that they work and the lenses are clean and undamaged. For brake lights, I press the pedal and ask someone to check, or use a suitable reflection.”
Check sidelights, dipped and main beam, rear lights and other fitted lamps. Know which switch operates each light. Daytime running lights may leave rear lights off.
3. Reflectors
Practice answer: “I visually check that the reflectors are present, clean and undamaged.”
Locate the rear reflectors before test day. Reflectors return light from another vehicle; they are different from lamps you switch on.
4. Indicators
Practice answer: “I operate each indicator and check outside that the fitted indicators work, with clean, undamaged lenses.”
Check both sides, including repeaters where fitted. A dashboard arrow alone does not prove every outside lamp works.
5. Engine oil
Practice answer: “On level ground, with the engine off and after the handbook’s waiting time, I remove the dipstick, wipe it, fully reinsert it and remove it again. The level should be between minimum and maximum.”
Point out the dipstick and the separate oil filler cap. For electronic oil-level systems, learn the manufacturer’s checking procedure. Never assume cap colour identifies the fluid.
6. Engine coolant
Practice answer: “With the engine cold, I check the coolant reservoir. The level should be between its minimum and maximum marks.”
Never open a coolant cap when the engine is hot. Identify the correct reservoir and use the specified coolant if topping up is needed.
7. Wipers and windscreen washer fluid
Practice answer: “I check that the wiper blades are in good condition and clear the screen properly. I identify the washer reservoir, check its level where visible and top up with suitable screenwash as required.”
Some washer bottles have no visible level marks. Follow the handbook. Practise operating the washers as well as the wipers; they are different functions.
8. Steering
Practice answer: “The steering should operate smoothly without excessive play. If power assistance fails it may become unusually heavy. I check that the assistance works with the engine running or the vehicle ready, as specified in the handbook.”
Learn your car’s system with your instructor. Electric steering may have no fluid reservoir. Do not force or hold the steering against full lock.
9. Brakes and parking brake
Practice answer: “The footbrake should feel firm, not spongy or sink excessively. When checked safely at low speed, the car should brake normally without pulling to one side. The parking brake should hold the vehicle securely.”
Learn the correct operation of a lever or electronic parking brake. Explain signs of a fault; only demonstrate a moving check when requested and safe.
10. Horn
Practice answer: “I operate the horn briefly where safe and lawful to confirm it works.”
Know where to press in your test car. Follow the tester’s instruction; avoid unnecessary sounding.
Extra under-bonnet checks to know
Brake fluid
Identify the reservoir and check the level against its MIN/MAX marks without removing the cap. If the level is at or below minimum, have the braking system checked by a garage.
Power-steering fluid, if fitted
Identify the reservoir and check against the appropriate level marks, following the handbook. Electric power steering does not require a hydraulic fluid reservoir.
Bonnet practice: Locate the release, open the safety catch and secure the bonnet as designed. Learn the correct closing method and confirm it is latched before driving. Keep clear of hot or moving components.
Secondary controls: practise inside the car
Find and operate each fitted control while safely parked with your instructor. Practise until you can locate it promptly.
- Lights: sidelights, dipped headlights, main beam and fitted fog lights. Learn the dashboard indicators and how to switch each off again.
- Visibility: front and rear wipers and washers, front demisting settings, fan, temperature and airflow, air conditioning where fitted, and the heated rear window.
- Signals: left/right indicators and hazard warning lights.
- Anti-glare mirror: the manual adjustment or automatic system fitted to your car.
- Driving position: seat, head restraint, mirrors and seat belt. Know how to adjust them before moving off.
Your final revision checklist
Tick each item after you can explain or demonstrate it confidently. Ticks are for this visit only.
Five-minute practice: Ask someone to pick three questions at random. Answer without reading, then locate the relevant components or controls in your parked car.
Vehicle readiness: Revision does not replace a roadworthiness check. Check your lights and tyres and resolve faults before test day. Review the RSA’s current vehicle and document requirements using the official link below.
Frequently asked questions
Do I need to memorise the exact wording?
Learn the meaning and explain the check clearly in your own words. Use these answers as prompts, then practise without the page.
Are these checks just for Tallaght?
This guide covers Category B car-test preparation in Ireland, including Tallaght, Leixlip and other test centres. The controls and components depend on your car.
Does an automatic car have technical checks?
Yes. Prepare the applicable checks and controls for the automatic car you will use. For an electric vehicle, ask your instructor to explain which components are fitted and how its checks differ.
What if I change cars before the test?
Repeat this checklist in the replacement car. Learn its bonnet release, fluid locations, lights, washers, demisters and parking brake before test day.
Is this the full driving-test revision guide?
This page focuses on technical checks and car controls. Also revise the Rules of the Road, road signs and hand signals, and prepare your driving skills with your instructor.
Test coming up? Prepare with Tony.
Book focused pretest preparation with Tallaght Driving School. Send your test date, test centre and whether you need to use your own car.
Safe driving first. Passing follows.
Official sources and further revision
Prepared by Tallaght Driving School. Guidance checked on 9 October 2026. Practice answers are teaching examples; this page is not an RSA publication.
